How To Repair Led Bulb In 1 Minute - NK's Methods

 

My friends welcome to my website
Today we are going to talk about another new topic, the name of the topic is how a bad LED bulb can be repaired at home.
What we used to do a few years ago: We used to install a ₹10 bulb at home, the ₹10 bulb gets spoiled quickly. And electricity was also used more. And we are not even able to repair it. The ₹10 bulb used to give yellow light and get damaged within a few days, but now we have started using LEDs.
We get 1 year guarantee on LED bulbs, but when our one year is over and our LED gets damaged, we throw it in a garbage heap and buy another LED bulb from the market.

Things You Will Need 

• Solder Iron
•  Electric Board
•  Small Screwdriver
•  Thin Wire
•  Safety Gloves Protection

Method

Today we will tell you how to make a new LED bulb thrown in the garbage at a very low cost. Your LED bulb which was damaged will last for 1 more year.
For this, first of all you have to take out the old bad LED bulb from the bulb holder, now you have to remove the lid on that bulb, now you have to put that bulb in the holder and turn on the switch. You have to be careful while doing this. Will have to be prepared.
Now you have to take a piece of wire which has to be bent from both the sides. For this you can take the help of tweezers. With the tweezers you have to touch each LED.
In fact, in an LED bulb, all the small LEDs are connected to each other in series. When any one LED gets fused, the flow of electric current in the entire circuit stops.
Due to this reason, that LED is not able to light. You have to touch all the LEDs one by one with the help of tweezers. You have to aim with a pencil at the LED which starts burning as soon as you touch it. Now, with the help of a small screwdriver, pry out that LED. have to give.
And a new LED has to be installed in its place. If you do not have an LED then you can short the point and connect the points to each other with the help of a soldering iron.
You will have to do this work very carefully, it will be very important for you to wear safety gloves.
Now you have to put the bulb back in the holder and turn on the switch. Now you will see that your bulb has started burning like before and it is completely fine. Now you put its top lid properly with the help of glue. .
And one more important thing, if you liked our post then please share it with your friends.